Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 49)

iTap 10 GigaBit Port Aggregator
45
The following table describes the status fields.
Field Name Value Description
System Status UP/DOWN DOWN indicates an internal error; call Net
Optics Customer Service for assistance
System Model 10G 62.5um
SR Inline
Identifies the device model
Power Supply 1
Status
ON/OFF Indicates whether the iTap Port Aggregator is
receiving power from Power Supply 1
Power Supply 2
Status
ON/OFF Indicates whether the iTap Port Aggregator is
receiving power from Power Supply 2
Link Status UP/DOWN Indicates the state of the communication on the
port
Peak Rate (%) <number> Highest utilization since last reset
Peak Date & Time mm/dd/
yyyy
hr:min:sec
When the peak rate occurred
Current Utilization
Rate (%)
<number> Utilization level of the port bandwidth (incoming
traffic on Network Ports, outgoing traffic on Moni-
tor Ports)
Total Packets <number> Total packets received
Total Bytes <number> Total bytes received
CRC Errors <number> Number of CRC errors
Oversize Packets <number> Number of oversize packets
Configure an iTap Port Aggregator
Use System Manager's Configure tab to set configuration parameters of an iTap
Port Aggregator.
To configure the iTap Port Aggregator:
1. Select the device you want to configure by clicking its icon in the System
Frame.
2. Click the Configure tab. The configuration information appears.