Net Optics iTap 10 GigaBit Port Aggregator - Manual (Page 57)

iTap 10 GigaBit Port Aggregator
53
Appendix B
Command Line Interface
Tip! _____________________________________________________________________
The command line interface (CLI) is not case sensitive.
__________________________________________________________________________
Command Sub-Command Syntax Description
Help Set help set Displays the set command
options
Reset help reset Displays the reset command
options
Show help show Displays the show command
options
Echo help echo Displays the echo command
options
Set IP set ip <address> Where <address> is the
IP address of the iTap for
Web Manager and System
Manager
Netmask set netmask
<address>
Where <address> is the IP
address netmask
Gateway set gateway
<address>
Where <address> is the IP
address of the gateway
Manager set manager
<address>
Where <address> is the IP
address of the remote man-
ager for SNMP traps
Threshold Port set threshold
<port ID>
<parameter>
Where <port ID> is A, B, 1,
or 2 and <parameter> is
0 to 100% of available
bandwidth
Time set time
<date & time>
Where <date & time> is
mm/dd/yyyy-hh:mm:ss
Display set display
<parameter>
Where <parameter> is
1 = Front panel display on
2 = Front panel display off
(other values not applicable)
Note: In the OFF state, the
display shows "Net Optics,
Inc." and the firmware
compile date