Asus T4-M3N8200 - Manual (Page 27)

2-9 ASUS T-Series M3N8200
2.6 Installing a DIMM
The system motherboard comes with two Double Data Rate 2 (DDR2) Dual Inline
Memory Module (DIMM) sockets.
The following figure illustrates the location of the sockets:
• Installing DDR2 DIMMS other than the recommended configurations
may cause memory sizing error or system boot failure. Use any of the
recommended configurations in the table on the next page.
• Install only identical (the same type and size) DDR2 DIMMs in DIMM_A1
and DIMM_B1.
• Always install DIMMs with the same CAS latency. For optimum
compatibility, we recommend that you obtain memory modules from the
same vendor.
• Due to chipset resource allocation, the system may detect less than 2 GB
system memory when you installed two 1 GB DDR2 memory.
• This motherboard does not support memory modules made up of 128 Mb
chips or double-sided x16 memory modules.
2.6.1 Memory configurations
You may install up to 8 GB system memory using 256 MB, 512 MB, 1 GB and 2
GB DDR2 DIMMs.
R
M3N18L
M3N18L 240-pin DDR2 DIMM Sockets
128 Pins 112 Pins
DIMM_A2
DIMM_B1
DIMM_B2
DIMM_A1
Recommended memory configurations
Sockets
DIMM_A1 DIMM_A2 DIMM_B1 DIMM_B2
Populated - - -
- Populated - -
- - Populated -
- - - Populated
Populated - Populated -
- Populated - Populated
Populated Populated Populated Populated
Mode
Single Channel
Dual-channel (1)
Dual-channel (2)