Asus T4-M3N8200 - Manual (Page 79)

5-28 Chapter 5: BIOS setup
5.5.5 APM Configuration
APM Configuration
Power Button Mode [On/Off]
Restore on AC Power Loss [Power Off]
Power On By PCI Devices [Disabled]
Power On By Onboard LAN [Enabled]
Power On By Ring [Disabled]
Power On By PS/2 KB [Disabled]
Power Button Mode [On/Off]
When set to On/Off, the system goes into On/Off mode when the power button
is pressed; When set to Suspend, the system goes into suspend mode when the
power button is pressed.
Configuration options: [On/Off] [Suspend]
Restore on AC Power Loss [Power Off]
When set to Power Off, the system goes into off state after an AC power loss.
When set to Power On, the system goes on after an AC power loss. When set to
Last State, the system goes into either off or on state, whatever the system state
was before the AC power loss. Configuration options: [Power Off] [Power On] [Last
State]
Power On By PCI Devices [Disabled]
When set to [Enabled], this parameter allows you to turn on the system through a
PCI LAN or modem card. This feature requires an ATX power supply that provides
at least 1A on the +5VSB lead. Configuration options: [Disabled] [Enabled]
Power On By Onboard LAN [Enabled]
Allows you to enable or disable onboard PCIE PME to generate a wake event.
Configuration options: [Disabled] [Enabled]
Power On By Ring [Disabled]
Allows you to enable or disable RI to generate a wake event.
Configuration options: [Disabled] [Enabled]
Power On By PS/2 KB [Disabled]
When set to [Enabled], this parameter allows you to use the PS/2 keyboard to turn
on the system. This feature requires an ATX power supply that provides at least 1A
on the +5VSB lead. Configuration options: [Disabled] [Enabled]
<Enter> to select
whether or not to
restart the system
after AC power loss.