Asus T4-M3N8200 - Manual (Page 73)

5-22 Chapter 5: BIOS setup
Bank Interleaving [Auto]
Allows you to enable the bank memory interleaving.
Configuration options: [Disabled] [Auto]
Enable Clock to All DIMMs [Disabled]
Enables or disables unused Clocks to DIMMs when memory slots are not
populated.
Configuration options: [Disabled] [Enabled]
MemClk Tristate C3/ALTVID [Disabled]
Enables or disables MemClk Tri-Stating during C3 and Alt VID.
Configuration options: [Disabled] [Enabled]
Memory Hole Remapping [Enabled]
Enables or disables the memory remapping around memory hole.
Configuration options: [Disabled] [Enabled]
DCT Unganged Mode support [Auto]
Configuration options: [Auto] [Always]
Power Down Enable [Enabled]
Enables or disables DDR power down mode.
Configuration options: [Disabled] [Enabled]
The following items appear only when the Power Down Enable item is set to
[Enabled].
Power Down Mode [Channel]
Configuration options: [Channel] [Chip Select]
DRAM Timing Mode [Auto]
DRAM Timing Configuration
Memory Clock Mode [Auto]
DRAM timing Mode [Auto]
Memory Clock Mode [Auto]
Allows you to select the memory clock mode.
Configuration options: [Auto] [Always]
DRAM timing Mode [Auto]
Allows you to select the DRAM timing mode.
Configuration options: [Auto] [DCT0]