Bell & Gossett 6 71 075 141B ecocirc wireless Potable Hot Water Recirculation Kit User Manual

Page 15

Advertising
background image

1.

Prepare the installation site, which is the faucet/tap farthest from the hot
water source.

2.

Close the hot and cold water riser shutoff valves and open the hot and cold
water faucets/taps to relieve the water pressure. Close the water faucets/
taps.
In some older homes, the riser shutoff valves may be difficult to shut off
completely. If so, turn off the water at the main water inlet valve to the
house.

3.

Remove the existing flexible line connections to the hot and cold water
faucet/tap threaded nipples.
Use a bucket to collect any excess drainage.
a)

If necessary, replace existing flexible hoses with new stainless steel
braided flexible hoses in the lengths required.

4.

Screw on the two existing 1/2” hose connections to the corresponding hot
and cold sides of the valve housing, denoted as “H” and “C” respectively.
Grip the valve only by the brass hex feature during assembly.
Be careful not to kink the existing hose lines while bending, which can
prevent adequate flow and/or cause the valves to break.
a)

Inspect the rubber washers in the hose connections to ensure that
they are in reusable condition. If not, replace.

5.

Screw the 3/8" compression end of the purchased flexible hoses to the
3/8" connections on the valve. Screw the 1/2" ends of these same two
hoses to the underside of the hot and cold water faucet/tap respectively.
a)

Make sure to match the hot and cold sides marked on the valve with
the corresponding faucet/tap.

b)

Make sure that the hot side connection is attached to the hot water
faucet/tap and the cold water side connection is attached to the cold
water faucet/tap

c)

Make sure that the hoses are long enough to allow the valve to be
positioned as planned.

6.

If desired, fasten the valve to the wall or vanity cabinet using the optional
mounting bracket and screws that are provided in the kit.

Installation

Bell & Gossett ecocirc

®

wireless Potable Hot Water Recirculation Kit Instruction

Manual

13

Advertising