Bell & Gossett 6 71 075 141B ecocirc wireless Potable Hot Water Recirculation Kit - Manual (Page 20)

Push-Button Operation
Follow this procedure when you add the push-button device to your system and
pair it with your ecocirc wireless pump and valve:
1.
Begin the pairing process by opening the timer cover on the pump and
performing the following sequence with the pump timer switch:
a)
Slide the switch from the “ON” position to the “OFF” position and wait
two (2) seconds.
b) Slide the switch to the “ON” position and wait two (2) seconds.
c) Slide the switch to the “OFF” position and wait two (2) seconds.
d) Return the switch to the “ON” position. A series of rapid flashes from
the LED light in the thermostat knob of the pump will indicate that it
has entered pairing mode. The pump will remain in pairing mode for
ten (10) minutes.
2. Power up the push-button / signal repeater device to be paired by
plugging it directly into a nearby outlet. While plugging the push-button
device into the outlet, depress and hold the push-button. Keep the push-
button depressed for five (5) additional seconds. Pairing mode on the
push-button / signal repeater is also indicated by a rapid series of flashes
from its own LED light and will remain in pairing mode until it
communicates and pairs with the pump.
3. Upon successful pairing, the LED light in the thermostat knob of the pump
will produce a steady glow, indicating that the pump is running or is on
stand-by. The LED light in the push-button device will produce a seldom
flash when the system is on stand-by or a steady glow when the pump is
running.
The push-button is now ready for service. Once the push-button / signal
repeater has been paired with the pump, it can be relocated to the desired
outlet without having to be re-paired.
The pump is capable of pairing with only two devices: the valve and the
optional push-button / signal repeater.
Signal Repeater Operation
When used as a signal repeater, the device will extend the operational range of
the ecocirc wireless hot water recirculation kit beyond the normally specified
distance. Device pairing is not required when used as a signal repeater. It will
aid in the transmission of data between the pump and valve in environments
where building construction or other factors may interfere with ongoing
communication.
When used as a signal repeater, the device should be installed at an outlet at an
intermediate location between the pump and valve.
Commissioning, Startup, Operation, and Shutdown
18 Bell & Gossett ecocirc ® wireless Potable Hot Water Recirculation Kit Instruction
Manual