Extron Electronics DMP 64 User Guide - Manual (Page 113)

Command ASCII command
(host to device)
Response
(device to host)
Additional description
Protected configuration
NOTE: The DMP 64 can save and recall a Personal Identification Number (PIN)-protected configuration, including
mic mixes, parameters, variables, and values (with the exception of the device’s IP address). The protected
configuration is useful to establish the DMP 64 in a known state, either as a troubleshooting tool or as a
baseline configuration.
Save the configuration E
S
X7) PCFG } PcfgS ] Save the configuration to the
protected memory location.
Recall the configuration E RPCFG } PcfgR ] Recall the protected
configuration
Change the PIN E
P
X7)
old *
X7)
new PCFG }
PcfgP X7)
new
] Overwrite the old PIN
(
X7)
old ) with the new one ( X7)
new ).
Query configuration saved
status E QPCFG } X7!]
NOTES:
X7)
= Personal Identification Number (PIN) Four numeric digits, default = 0000
X7! = Protected configuration status 0 = no protected configuration saved
1 = protected configuration saved
Command and Response Table for DSP SIS Commands (continued)
Table 1. X6) — Level Control and Mix-point Selection
NOTE: Circled numbers refer to DSP Processors Addressable by
SIS Commands on page 103.
a
Input Gain Control X6) b
Pre-mixer Gain X6)
Mic/Line Input 1 40000 Mic/Line Input 1 40100
Mic/Line Input 2 40001 Mic/Line Input 2 40101
Mic/Line Input 3 40002 Mic/Line Input 3 40102
Mic/Line Input 4 40003 Mic/Line Input 4 40103
Mic/Line Input 5 40004 Mic/Line Input 5 40104
Mic/Line Input 6 40005 Mic/Line Input 6 40105
e
Volume Out Control X6)
Output 1 60000
Output 2 60001
Output 3 60002
Output 4 60003
f
Virtual Return Gain X6)
Output A 50000
Output B 50001
Output C 50002
Output D 50003
DMP 64 • SIS Programming and Control 107