Extron Electronics DMP 64 User Guide - Manual (Page 99)

RS-232 Ports
The DMP 64 has two serial ports that can be connected to a host device such as a
computer running the HyperTerminal utility or DataViewer. The ports make serial control
of the switcher possible. Use the protocol information listed to make the connection.
For SIS programming details once the connection is made, see
Host-to-device
Communications on page 95.
USB Port (Front Panel)
The DMP 64 has a front panel USB port that can be connected to a host device such as
a computer running the HyperTerminal utility, or the DataViewer utility. The port makes
serial control of the switcher possible. For SIS programming details once the connection is
made, see
Host-to-device Communications on page 95.
Ethernet (LAN) Port
The rear panel LAN connector on the device can be connected to an Ethernet LAN or
WAN. Communication between the device and the controlling device is via Telnet (a
TCP socket using port 23). The Telnet port can be changed, if necessary, via SIS. This
connection makes SIS control of the device possible using a computer connected to the
same LAN or WAN. The SIS commands and behavior of the product are identical to the
commands and behavior the product exhibits when communicating via a serial port or
USB.
Ethernet Connection
The Ethernet cable can be terminated as a straight-through cable or a crossover cable
and must be properly terminated for your application (see figure 59).
12345678
RJ-45
Connector
Insert Twisted
Pair Wires
Pins:
A cable that is wired as TIA/EIA T568A at one
end and T568B at the other (Tx and Rx pairs
reversed) is a "crossover" cable. A cable wired the same at both ends is called
a "straight-through" cable because no pin/pair
assignments are swapped.
T568A T568B T568B T568B
Straight-through Cable
(for connection to a switch, hub, or router)
End 1 End 2
Pin Wire Color Pin Wire Color
1 white-orange 1 white-orange
2 orange 2 orange
3 white-green 3 white-green
4 blue 4 blue
5 white-blue 5 white-blue
6 green 6 green
7 white-brown 7 white-brown
8 brown 8 brown
Crossover Cable
(for direct connection to a PC)
End 1 End 2
Pin Wire Color Pin Wire Color
1 white-orange 1 white-green
2 orange 2 green
3 white-green 3 white-orange
4 blue 4 blue
5 white-blue 5 white-blue
6 green 6 orange
7 white-brown 7 white-brown
8 brown 8 brown
Figure 59. RJ-45 Ethernet Connector Pin Assignments
DMP 64 • SIS Programming and Control 93