Labeling the av inputs, Labeling the pvt decora face plates – Extron Electronics PVS 405D User Guide User Manual
Page 12
NOTES:
•
Use only the supplied 12 V, 4 A power supply for this switcher.
•
The PVS 405D power supply can support a typical system: for example,
a PVS 405D, 2 PVT Wallplates, 2 or 4 speakers, an MLC 104 IP Plus with an
IRCM DV+, and a VoiceLift Microphone system.
•
If an SCP 104 is used in the system, the MLC 104 IP Plus MUST have its
own power supply.
Labeling the AV Inputs
A sheet of corresponding labels is supplied for the installer to label the cables as an aid to
easy identification of the input signal type running from the PVT Wallplates to the switcher.
Once the labels are attached to the cables, the signal type transmitted on any cable can
clearly be identified, enabling correct cable connection during installation.
To label the cables,
1.
Peel off the label corresponding to the cable signal type (HDMI or RGB) and affix it
close to one end of the cable.
NOTE: Align and press the colored section of the label to the cable first, then
wrap the clear section around the cable, allowing the signal type name to be
easily read.
HDMI/RGB
Figure 4.
Wrap the label around the cable,
colored part first.
2.
Repeat step 1 for the other end of the cable,
using the same label type.
3.
Using the correct label type, repeat steps 1 and
2 as necessary for all signal cables that are to be
connected to the PVS 405D.
4.
Connect the designated input cable to the corresponding input.
Labeling the PVT Decora face plates
To help identify the input number and type of signal that any PVT Decora wallplate sends
to the PVS switcher when the wallplate is installed, a series of small labels are supplied.
A label identifying the transmitted signal type should be affixed to each Decora face plate
(top or bottom) where it can easily be seen after installation. This aids the user to connect
a device corresponding to the plate transmission signal type, allowing correct input
switching (for example input 1, input 3 and so on)
at the PVS 405D.
VGA IN
AUDIO
IN
OUT
LOCAL OUT
AUDIO IN
HDMI IN
IR OUT
S
G
HDMI IN #1
RGB IN #2
PVS 405D Switcher • Introduction
6