Extron Electronics PVS 405D User Guide - Manual (Page 17)

Power Save Modes
The PVS 405D is an ENERGY STAR qualified device, and has five power modes. See
table below for mode descriptions.
See the
“SIS Communication and Control” section, page 24 for relevant commands.
Mode Type Activation Device and
System power
Wake-up trigger Setup
Command
0 Normal None Fully powered. LED is
green. N/A Default state,
SIS command
reset
1 Auto
Power
Save Timed after setup.
If no audio signal
(from switchable
program inputs, Aux
input, and VoiceLift
input) is detected
for 25 consecutive
minutes, mode 2 is
enabled. Amplifier and rest of
system is powered until
mode 2 is entered. LED is
green in mode 1. An active audio signal
detected, or when an input
is switched, or if the volume
is adjusted.
The audio timer is reset.
Can also be woken by SIS
command (resets device to
Mode 0). By SIS
command or
Configuration
Software
(PCS).
2 Forced
Auto
Power
Save Instant Amplifier off. Rest of
system is powered. LED
is amber. If entered from mode 1, can
be woken by an active audio
signal, or when an input is
switched, or if the volume is
adjusted.
Reverts to mode 1. Either from
mode 1 or set
instantly by
SIS command.
If set instantly by SIS
command, can only be
woken by SIS command,
input selection, or volume
adjustment.
Reverts to the previously set
mode (0 or1).
3 Forced
Standby
Power
Save Instant Amplifier off. Wallplates
off. Rest of system is
powered. LED is amber
On PVS 405D, only USB,
RS‑232, network switch
ports, reset, and input
buttons are functional. Pressing the front input
toggle button, or switching
the inputs from the attached
MLC controller.
Reverts to the previously set
mode (0 or1).
Can also be woken by SIS
command. SIS command
only.
4 Forced
Network
Standby
Power
Save Instant Amplifier off. Wallplates
off. Rest of system is
powered. LED is amber.
On PVS 405D, only USB,
RS‑232, reset, and input
buttons are functional. Pressing the front input
toggle button, or switching
the inputs from the attached
MLC controller.
Reverts to the previously set
mode (0 or1).
Can also be woken by SIS
command. SIS command
only.
NOTE: Front USB and rear remote RS‑232 ports are powered and active all the time
regardless of the current power save mode.
PVS 405D Switcher • Operation 11