Outputs, Control and configuration, Power save – Extron Electronics PVS 405D User Guide User Manual
Page 8: Outputs control and configuration power save
Outputs
The PVS 405D has one HDMI output, an amplified audio output, and a line out audio
output for assistive listening or recording devices.
Control and Configuration
The PoleVault switcher can be controlled from either the front panel buttons, or software
via the front panel USB or RS‑232 control via a MediaLink controller.
The switcher has an RS‑232 port which can be connected to a MediaLink Controller for
remote control of the switcher and display. In addition an IR pass‑through port is available
for routing IR transport control signals from a controller to the source device.
In addition, the PVS 405D can be configured and controlled using the Extron Simple
Instruction Set (SIS) of commands or through the Extron Product Configuration Software
(PCS) program connected via the front panel USB port. This mini Type‑B female USB
connector located on the front panel can also be used for configuring the switcher
settings and flash upgrading the firmware.
Three 10/100 Base‑T network switch ports are also provided allowing network
connectivity for multiple other devices, such as MLC controller, TouchLink panel and
Ethernet controlled products, using a single LAN drop within the installation location.
Three front panel controls allow the user to adjust the independent input gains, the
VoiceLift microphone input level, and the Page Sensor sensitivity.
Power Save
This Product is an ENERGY STAR
®
qualified product. It has two Power Save modes
(Standard and Auto) that can be enabled or disabled by SIS commands, or through the
Product Configuration Software (PCS). When either of these modes are enabled and
the product is in a low power state, it can be taken out of that state by a front panel
operation.
See the
section on page 11 for full details and
Communication and Control section for SIS commands.
of the Extron Product
Configuration Software describes how to set the auto power save using PCS.
PVS 405D Switcher • Introduction
2