Extron Electronics TPS150 User Guide - Manual (Page 42)

Serial Communications, cont’d
TPS150 Switching and Transmission System • Serial Communications 4-14
Command/response table for programming and operating the TPT150
Command ASCII Command Response Additional description
(host to TPT150) (TPT150 to host)
Addressing
Connect [CC X1 ] {none} Connect the host computer to the
addressed unit. This command
is case sensitive.
Change address number [ADDR X1 ] [R0• X1 •ADDR X1 •] Change the TPT150’s address to
X1 and the displays to X1 +1.
Example: [ADDR95] [R0•95•ADDR95•] Change the transmitter’s address
number to 95 and the display’s to
96.
Reset address to factory default [ADDR@] [R0• X1 •ADDR@•] Reset the TPT150’s and display’s
addresses to the factory defaults
(97 and 98 [97 +1]).
Input selection
Select an input [CH X2 ] [R0• X1 •CH X2 •] Select input X2 to transmit to the
receiver and output to the
display.
Increment input selection [CH+] [R0• X1 •CH+•] Select the next higher input to
transmit to the receiver and
output to the display. If you
send this command when input 4
is selected, the transmitter wraps
around to select input 1.
Decrement input selection [CH–] [R0• X1 •CH–•] Select the next lower input to
transmit to the receiver and
output to the display. If you
send this command when input 1
is selected, the transmitter wraps
around to select input 4.
Query input selection [CH?] [R0• X1 •CH?• X2 ] Input X2 is selected.
Blanking and muting
Blank the output [BLANK1] [R0• X1 •BLANK1•] Mute the output video.
Unblank the output [BLANK0] [R0• X1 •BLANK0•] Unmute the output video.
Toggle the blank status [BLANK] [R0• X1 •BLANK•] Toggle the audio mute on and off.
Mute the output [MUTE011] [R0• X1 •MUTE011•] Mute the output audio.
Unmute the output [MUTE010] [R0• X1 •MUTE010•] Unmute the output audio.
Toggle the mute status [MUTE] [R0• X1 •MUTE•] Toggle (change the state of) the
audio mute).
Query mute status [MUTE01?] [R0• X1 •MUTE01?• X3 ] The audio output is X3
(0 = off [audio unmuted],
1 = on [audio muted]).