ABUS TVIP31550 - Manual (Page 138)

138
Digital output: This is the status of the digital output following an event (High – Switch output
closed; Low – Switch output open).
Trigger condition: This can be an event (Alarm) or schedule (Timer).
Alarm:
These settings define the activation of the digital switch output. A button for
configuring the corresponding alarm detector is available for each entry (if
configuration of the detector or trigger is possible).
Timer:
The period for activation of the switch output can be defined using the “Schedule”
button.
Alarm duration:
Indicates how long the output is active following an event (0-60 seconds).
Effective Period:
Always:
The detectors for these alarms are permanently activated.
Schedule: The detectors for these alarms are activated at defined schedules. Press the
“Schedule” button to configure these settings (see also the “Schedule” section).
Accept the settings by pressing “OK” or cancel them by pressing “Cancel”.
6.11 Schedule
Schedule selection:
Separate schedules can be assigned to each process (e.g. events, intervals etc.).
The corresponding process is then only active in the defined time schedule (see
list).
Start time:
Start of the active time schedule.
End time: End of the time schedule.