ABUS TVIP31550 - Manual (Page 83)

83
3.3 Installing the camera
Firstly, remove the white dome ring by turning it
anti-clockwise, then remove the dome.
Three through bores for fastening are found on the bottom of
the camera base plate (see diagram on right, items 1, 2 and
3).
Hold the camera as a template on the probable installation
site, mark the three fastening holes on the surface, then drill
the holes. Use the installation material provided to fasten the
camera in place.
The camera module can be tilted and rotated along three
axes.
Pan:
Rotation of the complete camera module
Tilt:
Tilt of the camera module
Rotation: Rotation of the lens with image sensor and IR
PCB (third axis)
IMPORTANT!
The camera must be disconnected from the mains power during installation.
1
2
3