Autel MaxiCheck EPB - Manual (Page 37)

35
are saved in the on-board computer's memory.
The O2 Monitor Test function allows retrieval and viewing of O2
sensor monitor test results for the most recently performed tests
from the vehicle's on-board computer.
The O2 Monitor Test function is not supported by vehicles which
communicate using a controller area network (CAN). For O2
Monitor Test results of CAN-equipped vehicles, see chapter
“On-Board Mon. Test”.
1) Use the UP/DOWN scroll button to select O2 Monitor Test
from Diagnostic Menu and press OK button. (Figure 5.3)
2) Wait a few seconds while the scan tool validates the PID MAP.
3) Use the UP/DOWN scroll button to select O2 sensor from O2
Monitor Test menu and press OK button. (Figure 5.23)
Figure 5.23
 If the vehicle does not support the mode, an advisory message
will be displayed on the screen. (Figure 5.24)