Abs/srs, Ehicle, Election – Autel MaxiCheck EPB User Manual
Page 76: Vehicle selection
74
9. ABS/SRS
The ABS/SRS diagnostic function is used to retrieve and clear
DTCs, display and save data streams or module information, and
perform various function tests on the vehicle‘s ABS/SRS systems.
It also provides the definition of each trouble code to help diagnose
problem areas within the system that have caused the Malfunction
Indicator Light to turn on.
NOTE: AUTEL accepts no responsibility for any accident or
injury arising from servicing the ABS/SRS systems. When
interpreting DTCs retrieved from the vehicle, always follow
the manufacturer’s recommendation for repair.
NOTE: All software screens shown in this manual are
examples, actual test screens may vary for each vehicle being
tested. Observe the menu titles and onscreen instructions to
make correct option selections.
Please follow these steps to start the ABS/SRS diagnostic testing
procedure:
1) Turn the ignition off.
2) Locate the vehicle‘s 16-pin Data Link Connector (DLC).
3) Plug the scan tool cable connector into the vehicle‘s DLC.
4) Turn the ignition on but do not start the engine.
5) Turn on the scan tool and wait for the Main Screen to appear.
6) Use the UP/DOWN scroll button or LEFT/RIGHT scroll
button to select AbsSrs in the Main Screen. (Figure 3.1)
9.1. Vehicle Selection
There are three ways for users to enter the vehicle information in the
scan tool.
A. Select vehicle step by step