Autel MaxiDiag Elite MD701 - Manual (Page 54)

52
Figure 6.25
4) View test results of selected O2 sensor. (Figure 6.26)
Figure 6.26
5) Use the UP/DOWN scroll button to view more screens of data if
additional information is available in more than one page.
6) Press the ESC button to return to the previous menu.
6.7 On-Board Monitor Test
The On-Board Monitor Test is useful after servicing or after
erasing a vehicle‟s control module memory. The On-Board
Monitor Test for non-CAN-equipped vehicles retrieves and
displays test results for emission-related power train components
and systems that are not continuously monitored. The On-Board
Monitor Test for CAN-equipped vehicles retrieves and displays
test results for emission-related power train components and
systems that are and are not continuously monitored. Test and
components IDs are determined by the vehicle manufacturer.
In this test, there are typically a minimum value, a maximum value,
and a current value for each monitor. By comparing the current value
… ……… . O2 Bank1 Sensor2 .
Rich-Lean Threshd V
Lean-Rich Threshd V
Low for Switch (V)
High for Switch (V)
Rich-Lean Threshd S
Lean-Rich Threshd S
……………. O2 Monitor Test …………..
The selected mode is
not supported!
Press any key to continue .