Autel MaxiDiag Elite MD701 - Manual (Page 78)

76
Figure 8.16
3) In the EPB screen, use the UP/DOWN button to select
Electric parking brake replacement. The screen shows as
below.
Figure 8.17
In the Electric parking brake replacement screen, the tool can
also perform three functions, which details could refer to the same
functions described in the Brake cable replacement menu above.
Active Test
During an active test, the tool is used for outputting commands to the
ECU in order to drive the actuators. This test determines the integrity
of the system or parts by monitoring the operation of the actuators or
by reading the EPB ECU data.
To carry out an active test, please follow these steps.
1. Follow the instructions above to display the Diag. menu
screen.(Figure 8.3)
Electric parking brake calibration
Activation done, a problem
occurred during the operation.
Press any key to continue
OK
Electric parking brake replacement
1.Put in fitting/removal position
2.Cable tensioning
3.Electric parking brake
calibration.