Iewing, Ehicle, Nformation – Autel MaxiDiag Elite MD701 User Manual
Page 58: 9 viewing vehicle information
56
3) If the test has been initiated by the vehicle, a confirmation
message will be displayed on the screen.
Figure 6.34
Some vehicles do not allow scan tools to control vehicle
systems or components. If the vehicle under test does not
support the EVAP Leak Test, an advisory message is
displayed on the screen.
Figure 6.35
4) Wait a few seconds or press any key to return to previous screen.
6.9 Viewing Vehicle Information
The Vehicle Info. function enables retrieval of Vehicle
Identification No. (VIN), Calibration ID Nos. (CINs),
Calibration Verification Nos. (CVNs) and In-use Performance
Tracking on 2000 and newer vehicles that support Mode 9.
1) Use UP/DOWN scroll button to select Vehicle Info. from the
Diagnostic Menu and press OK button. (Figure 6.3)
Component Test
Command Sent!
Press any key to continue
.............
Component Test
The selected mode is
not supported
Press any key to continue