Envizen HR702 - Manual (Page 6)

Unit Functions
4
5.1 Transmitter Module
1.ANT: 2.4G wireless audio/video signal antenna.
2.TV IN: R/L/CVBs input, from TV, Cable or Dish set top box.
3.TV OUT: R/L/CVBs output to TV set.
4.AV: AV combination input jack.
5.POWER: Connect 9V/1A DC power.
6.ON/OFF: Turn on/off the Transmitter Module.
1 2
3
4 5
6
5.2 Display Receiver
13
1
2
3
4
5
6
7
8
10
11
12
9
1.TV: Switch to TV/Cable or Dish Set Top Box.
2. : Adjust Brightness/Contrast/Saturation under Menu setup.
3. /VOL+: Adjust receiver unit volume up, and select Brightness/Contrast/Saturation/Reset
under Menu setup.
4.MENU: Go into Menu setup interface.
5. /VOL-: Adjust receiver unit volume down, and select Brightness/Contrast/Saturation/Reset
under Menu setup.
6. : Adjust Brightness/Contrast/Saturation under Menu setup.
7.AV: Switch to AV input channel.
8.ON/OFF: Turn on/off the Receiver.
9.USB Port (Firmware Upgrade): Do not open the rubber plug. It’s only used for future upgrades
if recommended by the manufacturer.
10.AV OUT: Pass-through AV output to other display/audio device.
11.EARPHONE: Stereo headphone jack. Please use only the provided earphones included for
optimal results.
12.DC IN 9V: Connect to 9V/1A DC power.
13.ANT: 2.4G wireless audio/video signal antenna.