Envizen HR702 - Manual (Page 9)

7
the battery be charged for 3 hours with the power off; While the battery needs to be charged
continuously for 8 hours if the Display Receiver is in use.
3.The battery life inside the receiver supports up to 2 hours usage without the adapter connected.
4.When the Receiver unit is switched off –
(a) A Red LED light indicates battery is being charged while the Receiver is not in use;
(b) LED light will be turned off whenever the battery is fully charged.
5.When the Receiver unit is switched on –
(a) Blinking Green power LED light indicates normal signal transmission state without charging the
battery;
(b) Alternate blinking Red and Orange LED light indicates normal operation while charging the battery;
(c) Alternate blinking Green and Orange LED light indicates battery capacity is low and plug-in power
is required to charge the battery immediately.
6-4. HR TV Display Receiver Operation
After properly setting up the Transmitter Module and Display Receiver units following the procedures
described above, you are ready to enjoy it and perform operation.
The Display Receiver screen will now display the relayed video and audio source program content.
Select the button on the Display Receiver that corresponds to the device you have connected ,
(TV/AV) input to view your source device. The Source input Channel will be displayed on the top left
hand corner of the screen whenever the corresponding button is clicked. It will disappear after 3~5
seconds after the button is released.
The channel you selected must correspond with the channel connected to the Transmitter Module.
NOTE: Should there be a problem receiving the source program on the Home Roam Display, see
“PAIRING” procedure outlined in Appendix to correct the problem.
Tip: Both Transmitter Module LED light and Display Receiver LED blink frequently to indicate normal
communication between the units.
Tip: Increase the source device audio level (if adjustment available) to a comfortable listening
level and then use the Home Roam TV display receiver volume controls to a comfortable level.
Setting up Home Roam TV
TV (or cable /dish set top box) input for an example:
A. Wait approximately one minute to warm up.
B. Switch your Home Roam TV LCD Display Receiver to TV mode, you will see the same
screen as your Cable / set top box or TV screen. Note source TV set does have to be
turned on to view program on Cable / Set top box.
C. You may connect with other devices such as DVD player, cable / dish box, VCR, etc.
Simply switch the corresponding mode by clicking buttons on the panel.