Envizen HR702 - Manual (Page 8)

Pass-through to a TV set: CONNECT HOME ROAM TV TRANSMITTER MODULE [TV OUT] TO
A LOCALLY CONNECTED TV SET TO PASS THROUGH ANY PROGRAM SOURCE CONNECTED
TO [TV IN].
NOTE: Not required if cable Set Top Box is connected to TV via HDMI.
Setting up Home Roam TV
6
6-2. HR TV Transmitter Module Operation
POWER UP HOME ROAM TV TRANSMITER MODULE
1.Plug in the AC/DC adapter to the Transmitter Module and a power outlet and press the button “ON”.
IMPORTANT: The Home Roam power adapter is only for use with Home Roam. Do not plug
the Home Roam power adapter into any other products.
2.The power LED light on indicates the Home Roam transmitter module is powered on.
3.Turn off the transmitter module unit will also turn off the LED indicator.
4.Red LED light indicates signal transmission is not ready, while Orange blinking LED light indicates
normal signal transmission state.
6-3. HR TV Display Receiver Connections
TURN ON YOUR SOURCE DEVICE AND HOME ROAM DISPLAY RECEIVER.
1.Plug in the AC/DC adapter to the HR Display Receiver a power outlet and slide up the “ON/OFF”
button on the left hand side of the Receiver unit.
IMPORTANT: The Home Roam power adapter is only for use with Home Roam. Do not plug
the Home Roam power adapter into any other products.
2.The power LED light on indicates the HR Display Receiver is powered on and charging the battery.
Tip: A rechargeable battery is incorporated into the 7” LCD Display receiver. It is recommended that