Aiwa NSX-DS8 - Manual (Page 16)

16
ENGLISH
RANDOM/REPEAT PLAY
Use the remote control.
RANDOM play
All the tracks on the selected disc or all the discs can be played
randomly.
REPEAT play
A single disc or all the discs can be played repeatedly.
Press RANDOM/REPEAT.
Each time it is pressed, the function can be selected cyclically.
RANDOM play — “RANDOM” lights up on the display.
REPEAT play — “
" ” lights up on the display.
RANDOM/REPEAT play — “RANDOM” and “ " ” light up on
the display.
Cancel — “RANDOM” and “
" ” disappear from the display.
To play all discs, press d to start play.
To play a single disc, press DISC DIRECT PLAY and within 3
seconds press 1, 2 or 3 to start play.
NOTE
During random play it is not possible to skip to the previously
played track with
f .
BLANK SKIP PLAY
The silent portions between tracks recorded on a CD can be
skipped during playback.
1 Press CD BLANK SKIP.
“CD BLANK SKIP ON” is displayed and “ ” appears in
the display.
2 Press d to start playback.
The silent portions between tracks will be skipped, and the
sound will be played back without interruption. If a track fades
out (ends with the sound gradually decreasing), the fadeout
portion also will be skipped.
To return to normal playback
Press CD BLANK SKIP again, and “CD BLANK SKIP OFF” is
displayed and “
” in the display disappears.
NOTE
• There may be a case where BLANK SKIP PLAY does not
function correctly.
• BLANK SKIP PLAY is automatically canceled when performing
AI EDIT RECORDING (page 19), PROGRAMMED EDIT
RECORDING (page 20), or recording during PROGRAMMED
PLAY (below) or RANDOM PLAY (above).
PROGRAMMED PLAY
Up to 30 tracks can be programmed from any of the inserted
discs.
Use the remote control.
1 Press PRGM twice in stop mode.
“PRGM” is displayed .
• When PRGM is pressed once in step 1, the unit enters the
KARAOKE PROGRAM (page 27).
2 Press DISC DIRECT PLAY and within 3 seconds
press 1, 2 or 3 to select a disc.
Go to the next step when the tray stops rotating.
3 Press numbered buttons 0-9 and +10 to program
a track.
Example:
To select the 25th track, press +10, +10 and 5.
To select the 10th track, press +10 and 0.
4 Repeat steps 2 and 3 to program other tracks.
5 Press d to start play.
To check the program
Each time f or g is pressed in stop mode, a disc number,
track number, and program number will be displayed.
To clear the program
Press s CLEAR in stop mode.
To add tracks to the program
Repeat steps 2 and 3 in stop mode. The track will be programmed
after the last track.
To change the programmed tracks
Clear the program and repeat all the steps again.
To play the programmed tracks repeatedly
After programming the tracks, press RANDOM/REPEAT
repeatedly until “
" ” appears on the display.
NOTE
• During programmed play, you cannot perform random play,
check the remaining time, and select a disc or track. “Can’t
USE” is displayed if you attempt to select a track.
• “FULL” is displayed if you attempt to program more than 30
tracks.
Selected track number Total number of selected tracks
Program number Total playing time of
the selected tracks
PRGM