Ai edit recording – Aiwa NSX-DS8 User Manual

Page 19

Advertising
background image

En

ENGLISH

19

AI EDIT RECORDING

The AI edit recording function enables CD recording without
worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track length.
If necessary, the order of tracks is rearranged so that no track is
cut short.
(AI: Artificial Intelligence)

NOTE

AI edit recording will not start from a point halfway into the tape.
The tape must be recorded from the beginning of either side.

1 Insert the tape into deck 2.

Insert the tape with the side to be recorded on first facing out
from the unit.

2 Press CD and load the disc(s).

3 Press CD EDIT/CHECK once.

“EDIT” and “AI” are displayed.

• When “PRGM” is displayed, press CD EDIT/CHECK.

4 Press DISC DIRECT PLAY 1-3 to select a disc.

5 Press numbered buttons 0-9 on the remote

control to designate the tape length.

10 to 99 minutes can be specified.
Example: When using a 60-minute tape, press 6 and 0.
In a few seconds, the tracks to be recorded on each side of
the tape are determined.

f

,

g

or MULTI JOG are also available to designate

the tape length.

6 Press

w

REC/REC MUTE to start recording on

the first side.

The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.

To stop recording

Press

s

. Recording and CD play stop simultaneously.

To clear the edit program

Press

s

CLEAR twice so that “EDIT” disappears on the display.

To check the order of the programmed track numbers

Before recording, press CD EDIT/CHECK to select side A or B,
and press

f

or

g

repeatedly.

To add tracks from other discs to the edit program

If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment.
1 Press CD EDIT/CHECK to select side A or B.
2 Press DISC DIRECT PLAY 1-3 to select a disc.
3 Press numbered buttons on the remote control to select tracks.

A track whose playing time is longer than the remaining time
cannot be programmed.

4 Repeat steps 2 and 3 to add more tracks.

Time on cassette tapes and editing time

The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape’s specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).

NOTE

• The AI edit recording function cannot be used with discs

containing 31 tracks or more. “TR OVER” is displayed if this is
attempted.

• Recording is inhibited if the erasure prevention tab on either

side of the tape is broken off.

Tape length

Remaining time
of recording

Programmed
tracks for side A

Tape side
A: First recording side
B: Second recording side

EDIT

Track number

Programmed
track numbers

Program number

Tape side

RECORDING

Advertising