CHIEF XPAU Series - Manual (Page 12)

XPAU Installation Instructions
12
6. Insert tabs on one side of lower cover (D) into
corresponding slots on side of column assembly. (See
Figure 20)
7. Manipulate lower cover (D) so that it fits within lower cavity
of column assembly and insert tabs on other side of lower
cover (D) into corresponding slots on side of column
assembly. (See Figure 20)
Figure 20
8. Use six #10-24 x 1/2” button head cap (X) or security (Y)
screws to secure upper cover (E) and lower cover (D) to
back of column (F). (See Figure 21)
Figure 21
Adjustments
Height Adjustment
1. Turn height adjustment knob clockwise to raise display.
(See Figure 22)
2. Turn height adjustment knob counterclockwise to lower
display. (See Figure 22)
WARNING: Do not attempt to raise or lower the adjustment
carriage beyond its upper or lower limit. High and low points
are shown in Figures 22 and 23.
NOTE: A 1/2” socket wrench or drill may also be used to adjust
height by turning bolt just above height adjustment
knob.
Figure 22
Figure 23
6
6
7
(D)
(X) x 6
(Y) x 6
8 or
1
high point
2
height adjustment knob
1
2
low point