CHIEF XPAU Series - Manual (Page 6)

XPAU Installation Instructions
6
Assembly And Installation
CAUTION: Attachment holes may be damaged if a power
drill is used to insert button head cap screws. Screws should
first be inserted and turned BY HAND with the hex key or with
a hand-held screwdriver BEFORE using the hex head drill bit
and power drill to complete the attachment.
Cart Assembly
1. Carefully set column assembly (F) on its left side. (See
Figure 1)
2. Place right transition cover (P) on right cart leg (J), lining up
the holes on the cover with the holes on the leg and column
assembly base. (See Figure 1)
3. Use two 5/16-18 x 3 3/4” button head cap screws (R) to
secure leg (J) and cover (P) to column assembly (F). (See
Figure 1)
Figure 1
4. Turn column assembly (F) onto its right side. (See Figure 2)
5. Place left transition cover (N) on left cart leg (H), lining up
the holes on the cover with the holes on the leg and column
assembly base. (See Figure 2)
6. Use two 5/16-18 x 3 3/4” button head cap screws (R) to
secure leg (H) and cover (N) to column assembly (F). (See
Figure 2)
Figure 2
Accessory Bracket Installation (Optional)
NOTE: Accessory bracket may be installed to either side of
column.
1. Loosely install two #10-24 x 3/8” Phillips head machine
screws (M) through two #10 washers (AA), holes in
accessory bracket (G) and into two #10-24 square nuts (Z).
(See Figure 3)
2. Insert two #10-24 square nuts (Z) into two openings on
column channel. (See Figure 3)
3. Lift accessory bracket (G) to desired mounting position.
(See Figure 3)
4. Tighten screws to secure in position. (See Figure 3)
Figure 3
1 (F)
(J)
(P) 2
3 (R) x 2
(rear view)
(R) x 4
(H)
(N)
6
4 (F)
5
(Z) x 2
2
1 (M) x 2
(AA) x 2
2
3
(G)