CHIEF XPAU Series User Manual
Page 7
Installation Instructions
XPAU
7
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components installed to the accessory bracket (G) does
not exceed 10 lbs (4.54 kg). Exceeding the weight capacity
may result in damage to the equipment or components!
IMPORTANT ! : Do NOT attach accessory bracket too
high on column or above height adjustment mechanism
or it could interfere with the height adjustment
mechanism. See Height Adjustment Section for details.
5.
Install components to accessory bracket as desired using
cable ties (V) or screws. (See Figure 4)
NOTE:
Accessory bracket is designed to mount small audio/
video components such as power strips, media
players, etc.
Figure 4
CPU Installation (Optional)
1.
Route CPU strap (Q) through hole on lower bracket and
around CPU to secure CPU to column base. (See Figure 5)
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components installed to the lower bracket does not
exceed 20 lbs (9.07 kg). Exceeding the weight capacity may
result in damage to the equipment or components!
NOTE:
CPU strap is designed for use with larger non-rack
mountable CPU’s or audio/video components.
Figure 5
Vertical Rack Bracket Installation (Optional)
NOTE:
Vertical rack brackets (C) are intended for use with
various types of rack mountable products.
1.
Loosely install two #10-24 x 3/8” Phillips head machine
screws (M) through two #10 washers (AA), holes in vertical
rack bracket (C) and into two #10-24 square nuts (Z). (See
Figure 6)
2.
Insert two #10-24 square nuts (Z) into two openings on
column channel. (See Figure 6)
3.
Lift vertical rack bracket (C) to desired mounting position.
(See Figure 6)
4.
Tighten screws to secure in position. (See Figure 6)
IMPORTANT ! : Do NOT attach rack brackets higher
than 22" above the base extrusion or they could interfere
with the height adjustment mechanism. See Height
Adjustment Section for details.
5.
Repeat Steps 1-4 on other side for other bracket.
Figure 6
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components installed to the vertical rack brackets (C) does
not exceed 20 lbs (9.07 kg). Exceeding the weight capacity
may result in damage to the equipment or components!
6.
Install rack mountable components to vertical rack brackets
(C) as desired using standard rack screws (not included).
power strip (example)
(V)
(Q)
CPU (example)
hole on lower bracket
(M) x 2
1
2
3
(AA) x 2
(C)
(Z) x 2