Analog Way Saphyr - Manual (Page 51)

51
8.2.2 Input selection settings
You can find several settings for each input (some settings are specific to some signal type):
- INPUT STATUS: display the input status,
- AUTOSET: launch an automatic setup on the inputs,
- FREEZE: freeze the input,
- ACTIVE PLUG: choose the active plug of the input,
- TYPE: to set up your input type (Computer, Video etc..),
- AUTOSET: launch an autoset on this plug,
- ENABLE: enable/disable the input#,
- SYNCHRONIZED: enable this option when you source is from the same refresh rate than the reference rate,
- HDCP ENABLE: enable/disable the HDCP automatic detection,
- HSYNC LOAD: to change the load of the sync signal,
- 3D COMBO FILTER: choose manually the combo filter for interlaced source,
- FORMAT: for analog source, choose to force a analog format,
- AUDIO INPUT: select the input audio source according to the input video source,
- EDID: set up your EDID for the selected plug,
- STATUS: to summarize the input status.
Concerning the HDMI inputs, a specific feature allows enable/disable the HDCP receiver for the input chosen.
It can be very useful especially using a Mac: Input menu > HDMI # > HDCP detection
NOTE: The input status is available at any time in the status input menu and can give you information about
format rate and HDCP status.
8.2.3 Source Output selection
Once your inputs all have been configured, the output settings of the Saphyr must be set according to the
machines plugged on your Saphyr Program and Preview outputs (video projector, Preview monitor...).
NOTE: If you want to use HDCP content from your sources, be sure to attach HDCP compliant screens or
projectors. If HDCP sources are used with non-HDCP compliant screens, the output image could be
disabled.
8.2.4 Output selection settings
To set up the output, go in the Program Output or Preview Output menu and choose first the adapted format/
resolution, and then the appropriate rate for your screens by using the knob button and the ENTER button.
Program Output > Output Format > Output rate
Please note that a pair format/rate is only applied when the rate is validated.
Use the native resolution of your screens/projectors in order to obtain the best image quality. In the Preview
Output menu, you can also match the output configuration the Program Output to the Preview Output by
checking the case Sync w/Out 1. It allows you to set up your outputs via the output 1 menu.
Preview output > Synch w/Out 1
Some other settings are available too:
- OUTPUT STATUS: display the status of the selected output,
- OUTPUT FORMAT: choose the output format,
- OUTPUT RATE: choose the output rate,
- GAMMA: use this feature to set up the output gamma,
- ANALOG TYPE: set up the type of synchronization of your analog output,
- DVI TYPE: set up the type of color space of your digital output,
- DVI as HDMI: DVI output content as HDMI. Audio is included,