eLine Technology ECO3 User Manual - Manual (Page 31)

31
Net DVR
Chapter 4 Device Operation
4.1 Power On/off and Login /Lock
Power on: After connected up the power cable, the front panel of the DVR will start and enter the st andby state. Click the “power” button on the
remote controller for 3 seconds to enter the running state.
Power off: When the system is under the running state, click “power” button on the remote controller to popup the shut down interface. And clicked
the “confirm” button, the system will enter the standby state.
Login/Lock:To avoid unauthorized user using the machine or influencing the system’s normal working, we speciall y set the key lock and unlock
function for the machine.
4.1.1 Keystroke Unlock/Lock
When multi DVRs are put to work together, using the remote controller may influence the machin es which users do not intend to control. So we
set system key lock function correspond to remote control. Under the system management of DVR main m enu, please enter series configuration and
setup device number, then enable key lock and save it. Now to press the DN button on the remote cont roller, the DVR is locked, and you will see the
"LOCK" light on the front panel is on.To unlock the DVR ,please press the DN button and input the c orresponding DVR device number(Device
number range is 1-99,default set is 1).
Note: If the remote control does not respond, please check if this function is enabled.