eLine Technology ECO3 User Manual - Manual (Page 36)

36
User Manual
 Encoding stream: When compressing the intense moving image, we should make a upper limit of the compression bitrate, there are (unit: bps):
100K,128K,256K,512K,1M(Under the CIF maximizing the 1M.Note: the more intense of the movement, the h igher bite rate you should set).
 Video quality:There are 6 levels of video quality(highest, higher, high, middle, low, lowest).
 Audio:The on/off switch for audio(Tick off indicates open, otherwise means off).
 Dual streams
1.The parameters of local stream are for main stream. The local stream parameter settings affect the recording main stream and network main stream.
2.The parameters of net stream are for sub stream. The net stream parameter setting affect network s ub stream.
 Pre-record time: The 4 record modes support Pre-record function, default pre-record time is 10s, ran ge is 0-30s. Due to the variable bitrate, the
actual pre-record time may have some difference with what your set.
 Delay record time :The record duration time when the motion/sensor alarm appears, default duration t ime is 30s,range is 0-180s.
4.3.2 Manual Record
After login, click the “Manual” on the lower left corner,or press the
“Record” button on the remote controller to enter the manual record interface,
the figure is as follows:
When the channel button turns yellow,the manual record is started,
otherwise the button is grey.Once the manual recording is started, it will not
stop recording until manual closing.If the power is off abnormally, the recording
will continue after the power is on.