eLine Technology ECO3 User Manual - Manual (Page 41)

41
Net DVR
4.5 Alarm Setup
4.5.1 Motion Detection
1.After login, click “main menu”-> “alarm setup”,the interface is as follows:
By analyzing the real-time video, the system could confirm whether the video scene has changed or not. If you need record when the video scene
is changed, then you can through “Motion Detection” to perform it, user could set the motion detection time, schedule time, sensitivity, detection area,
alarm output channel and whether enable audio alarm.The specific operation steps of motion detection setup is as follows:
(1) After login, through “main menu”-> “record setup”-> “record parameter” to set the corresponding channel pre-record time and delay record 
time.
(2) Choose the motion record channel. 
(3) Set the schedule time(the specific setting please refer to schedule record). 
(4) Select the sensitivity:The sensitivity of the motion detection is adjustable and the sensitivity goes up in order from 1 to 5.When the motion 
detection of the current channel happens, the system will alarm and record. If the sensitivity is low, such as “1”,when the video scene make a big change,
the system will motion detection alarm; If the sensitivity is high, such as “5”,when the video scene make little change, the system will motion detection
alarm.
(5) Setting detection area:
Before you start the motion detect, you should define which areas are detection areas, then when ima ge is changed in these areas, it will detect and make
alarm. System default yellow area is detection area.
Setting detection area by remote controller.Press direction button, move the cursor to set the start point,then move cursor to the area you want to be
the end point. Press the confirm button to finish the operation. Left click the mouse to change the status of the motion detection square unit. Then
press “return” button to the record setup status ,click “save” to activate the setup.