eLine Technology ECO3 User Manual - Manual (Page 61)

61
Net DVR
4.11.1 Client Software Upgrade
 Please double check the version of the upgrade software, so you can restore to the former version w hen your upgrade is failed. If your system are
running well or just don't need the new function, we recommend you keep the default version. Please backup the important record files before upgrade.
 Do ensure supplying the power and the stability of network when upgrading. Network outages and inte rrupted power supply will cause upgrading
failure. On a PC client remote upgrade download files completed, the host-side did not appear “the u pdate was successful, which is resuming the
equipment, please be later...”,in six minutes, you can shut down and then reboot, then check whether the host computer update was successful.
 Please double check the version of the upgrade software, including machine model and boot interface, and make sure whether it corresponds to your
system.If you have any doubts, don’t upgrade, or in case you fail to upgrade the firmware, you can n either redo the system upgrade nor restart the
machine(These upgrade failure machine must send back to the factory).
 After upgrade, for the new features, please refer to the user manual of the new version. You can get the new version from our website or the suppliers.
 Don’t modify the software(including the name of the firmware), otherwise, we will take no responsib ility and will not provide free update.
 Make sure the client installation procedure is the same as the system.
The procedure is as follows:
1. Connect the Net DVR to PC by coherent network cable or LAN (pay attention to IP conflict).
2. Before upgrading, please confirm the IP address of host computer, then enter client end.
3. After login and choose “system” -> “Remote update”.
4. Choose “Browse”, choose the file to be updated, and refer to the following figure(left figure).
5. The following figure is displayed on DVR (right figure).
4.11 Software Upgrade
There are 2 ways for firmware upgrade:1.Client software upgrade;2.USB device upgrade.Please read the statement carefully before upgrade.