eLine Technology iVMS-2000 V2.0.2 - Manual (Page 98)

iVMS-2000 User Manual
93
Figure 6-36 Copy Video Loss Linkage Configuration
6.6.2 Modify Alarm Actions
Select an alarm input and modify the alarm input configuration; or select an alarm input
under a certain camera and modify all the alarm configuration for each camera; or select an
exception alarm type and modify all the alarm types.
Alarm linkage modification steps are generally the same as add alarm linkage, except for
the region settings under motion detection/ video loss link configuration.
Set Motion Detection Area (Figure 6-37):
Figure 6-37 Set Motion Detection Area
Click [Region] during motion detection alarm modification and enter “Set Motion
Detection Area” dialog box. Users can drag the mouse and draw the motion detect area, and
also adjust the position and size of the region. After motion detect region has been configured,
adjust the sensitivity level and click [Start Test]. If there is motion detected in the region, the
brims of the blocks in the motion detection areas will flicker in red/green/blue colors.
Notes: iVMS-2000 supports up to 8 regions for each camera’s motion detection, and
there is 7 levels for sensitivity.
Set Video Tamper Area (Figure 6-38):