A&D Super Wash Down Scales SW-150KL - Manual (Page 35)

33
‰ Five-level comparator mode…Set the HIHI limit value.
Three-level comparator mode…Set the HI limit value.
(No reply for the function setting “
aCk 0
“.)
Set the six-digit value excluding the polarity and decimal point.
Command H 2 , + 0 0 0 4 0 0 C
R
L
F
Reply H 2 , + 0 0 0 4 0 0 C
R
L
F
‰ Five-level comparator mode…Set the HI limit value.
Three-level comparator mode…Not used.
(No reply for the function setting “
aCk 0
“.)
Send the six-digit value excluding the polarity and decimal point.
Command H 1 , + 0 0 0 3 0 0 C
R
L
F
Reply H 1 , + 0 0 0 3 0 0 C
R
L
F
‰ Five-level comparator mode…Set the LO limit value.
Three-level comparator mode…Not used.
(No reply for the function setting “ aCk 0 “.)
Send the six-digit value excluding the polarity and decimal point.
Command L 1 , + 0 0 0 2 0 0 C
R
L
F
Reply L 1 , + 0 0 0 2 0 0 C
R
L
F
‰ Five-level comparator mode…Set the LOLO limit value.
Three-level comparator mode…Set the LO limit value.
(No reply for the function setting “
aCk 0
“.)
Send the six-digit value excluding the polarity and decimal point.
Command L 2 , + 0 0 0 1 0 0 C
R
L
F
Reply L 2 , + 0 0 0 1 0 0 C
R
L
F
Replies to the commands other than examples above when the function setting “ aCk 1 “ is
selected .
‰ The scale is not in a state where a command could be executed. Then, the scale will reply “I”.
Command Z C
R
L
F
Reply I C
R
L
F
The scale is not in a condition that zero operation is possible.
‰
Command does not exist for the scale. Then, the scale will reply “?”.
Command B C
R
L
F
Reply ? C
R
L
F
The scale received an undefined command.
‰
When the function setting “
aCk 0
“ is selected, undefined commands are ignored
and no reply is sent.