Burkert Type 8798 - Manual (Page 11)

11
Control and display elements
6.7. electrical data
Connections: Linear Remote Sensor:
Round cable 10 m
Rotating Remote Sensor:
Round cable 2 m shielded (maximum
extension 10 m)
Power supply: (via the position controller Type 8791 or
Type 8792/8793)
Linear Remote Sensor:
24 V DC ± 10 %
Rotating Remote Sensor:
10 ... 30 V DC
Power consumption: Linear Remote Sensor: < 0.3 W
Rotating Remote Sensor: < 0.8 W
Protection class: 3 in accordance with VDE 0580
Communication: via serial interface RS485 (included in the
supply cable)
7. cOnTrOl and display
elemenTs
Special operation of this Remote Sensor is not necessary. The nec-
essary settings are made on the position controller Type 8791 or Type
8792/8793 (see relevant chapter of the position controller operating
instructions).
7.1. display elements of the linear
remote sensor
2 LEDs, which are also visible from outside through the transparent
hood, display the sensor mode.
status
led 1
yellow status
led 2
red
display remedial action
off off
No operating
voltage
Check the power supply
of position controller
Type 8791,
Type 8792/8793.
Check the cable con-
nection configuration.
flashing on
Sensor is operated
outside the cov-
erage area.
Check adaption to drive;
the puck on the switch
spindle must not exceed
the sensor surface.
flashing off
Sensor is in operation and sending position
value
Tab. 1: LED display elements; linear Remote Sensor
English
Type 8798