Burkert Type 8186 - Manual (Page 16)

-
As basic adjustment, but also reset of special parameters to
the default values
2 )
l Peak values measured value and temperature 3 )
-
Reset of the min./max. values of pressure, level and temper-
ature to the current values
Information:
Because the reset values are nearly sensor-specifc, they are listed in
the operating instructions manual of the respective sensor.
Reset
Select reset?
In this menu item you select the internal arithmetic unit of the sensor.
With radar, guided microwave and ultrasonic sensors this is m(d) or
ft(d).
For pressure transmitters more comprehensive units are available.
They are described in the operating instructions manual of the
respective sensor in the menu "Basic adjustments".
Unit of measurement
m(d)
The sensor is already set to the ordered national language. In this
menu item you can change the language. The following languages are
available, e.g. in software version 3.50:
l Deutsch
l English
l Français
l Espanõl
l Pycckuu
l Japanese
l Italiano
l Netherlands
l Japanese
l Chinese
2 ) Special parameters are parameters which are set customer-specifically on
the service level with the adjustment software PACTware.
3 ) Temperature only with pressure transmitters and ultrasonic sensors.
Service/Adjustment unit
Service/Language
16 Indicating and adjustment module
5 Setup - Sensors up to software 3.99
41787
-EN
-120316