Burkert Type 8186 - Manual (Page 8)

The electrical connection is carried out via spring contacts in the
sensor and contact surfaces in the indicating and adjustment module.
After mounting, the sensor and indicating and adjustment module are
also splash-water protected without housing cover.
The range of functions of the indicating and adjustment module is
determined by the sensor and depends on the respective software
version of the sensor.
Power is supplied directly via the respective sensor or the external
indicating and adjustment unit. An additional connection is not
required.
The backlight is also powered by the sensor. Prerequisite for this is an
operating voltage at a certain level. The exact voltage specifications
can be found in the operating instructions manual of the respective
sensor.
3 .3 Packaging, transport and storage
Your instrument was protected by packaging during transport. Its
capacity to handle normal loads during transport is assured by a test
according to DIN EN 24180.
The packaging of standard instruments consists of environment-
friendly, recyclable cardboard. For special versions, PE foam or PE foil
is also used. Dispose of the packaging material via specialised
recycling companies.
Transport must be carried out under consideration of the notes on the
transport packaging. Nonobservance of these instructions can cause
damage to the device.
The delivery must be checked for completeness and possible transit
damage immediately at receipt. Ascertained transit damage or
concealed defects must be appropriately dealt with.
Up to the time of installation, the packages must be left closed and
stored according to the orientation and storage markings on the
outside.
Unless otherwise indicated, the packages must be stored only under
the following conditions:
l Not in the open
l Dry and dust free
l Not exposed to corrosive media
l Protected against solar radiation
l Avoiding mechanical shock and vibration
l Storage and transport temperature see chapter "Supplement -
Technical data - Ambient conditions"
l Relative humidity 20 … 85 %
Range of functions
Voltage supply
Packaging
Transport
Transport inspection
Storage
Storage and transport
temperature
8 Indicating and adjustment module
3 Product description
41787
-EN
-120316