Burkert Type 8186 - Manual (Page 17)

Language
German
With this function
l Load parameter adjustment data from the sensor into the
indicating and adjustment module
l Write parameter adjustment data from the indicating and adjust-
ment module into the sensor
The data are permanently saved in an EEPROM memory in the
indicating and adjustment module and remain there even in case of
power failure. From there, they can be written into one or several
sensors or kept as backup for a possible sensor exchange.
Kind and volume of the copied data depend on the respective sensor.
Information:
Before data are written into the sensor, a check is carried out to
determine whether the data fit the sensor. If the data do not fit, a fault
signal is triggered or the function is blocked. When writing data into the
sensor, you will see which instrument type the data originate from and
which TAG-no. this sensor had.
The following items are checked:
l Software version
l WHG approval
l SIL activated
l Measuring principle
l Radar C-band/K-band
l Radar measuring range < 30 m or > 30 m
l Signal output
l Pressure measuring range
Copy sensor data
Copy sensor data?
In this menu item, the PIN is activated/deactivated permanently.
Entering a 4-digit PIN protects the sensor data against unauthorized
access and unintentional modifications. If the PIN is activated
permanently, it can be deactivated temporarily (i.e. for approx. 60 min.)
in any menu item. The instrument is delivered with the PIN set to 0000.
Service/Copy sensor
data
Service/PIN
Indicating and adjustment module 17
5 Setup - Sensors up to software 3.99
41787
-
EN
-
120316