Clear-Com Eclipse-Omega - Manual (Page 57)

Clear-Com Communication Systems
Eclipse Matrix Installation Instruction Manual 4 - 2 7
Figure 4-19: Rear View of IMF-3 Frame
To External Device
To connect external devices to an RLY-6 interface, use the two DB-9M
connectors on the rear cable assembly panel for the interface. Figure
4-20 shows the pin assignment of these connectors as viewed from
the frame side of the connector.
If a DB-9F is plugged into the connector labeled CH. A I/O, relays 1 to
3 are available on that connector. The connector labeled CH. B I/O has
the contacts for relays 4 to 6. In Figure 4-20, the labels on the pins
apply to either connector. Example: #1/4 COM refers to the wiper of
relay 1 if it is connected to CH. A and the wiper of relay 4 if it is
connected to CH. B.
Ports
Rear View of IMF-3 Frame
GPI/RLY
Interface
Connector
RJ-45 RJ-45 RJ-45 RJ-45 RJ-45
DB-9 DB-9 DB-9 DB-9 DB-9
RJ-45 RJ-45 RJ-45 RJ-45 RJ-45
DB-9 DB-9 DB-9 DB-9 DB-9
Other
Interfaces
RLY-6
#2
GPI-6
#2
GPI-6
#1
RLY-6
#1