Clear-Com CellCom Battery Pack Charger - Manual (Page 161)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
1 0 - 9
Figure 10-12: Beltpack Serial Number
This performs two actions - firstly it sends the system number and
DECT carrier mask information to the beltpack, and secondly it stores
the serial number of the beltpack in the basestation configuration.
If the program connects successfully with the beltpack, the "Serial
Num" field will change to show its serial number.
Once a beltpack has been registered with the basestation it will have
been programmed with the system number and DECT carrier mask
information which should not change once the system is installed. The
beltpacks can later be reassigned to different slots on the same
basestation via the configuration editor or via the basestation front
panel.
It is also possible to pre-register spare beltpacks and then add them to
the system later by entering the beltpack serial number into the
configuration editor or the basestation.
THE OVERVIEW BUTTON
Clicking the overview button shows a summary of the labels and serial
numbers of the beltpacks registered in each slot. By default only the
first ten beltpacks are enabled; to enable beltpacks 11-20 a password
must be obtained from Clear-Com or an authorized distributor.
Figure 10-13: Beltpack Overview
Click on ‘OK’ to close the Overview window. To enable the beltpacks
please refer to “System Tab” on page 24.