Clear-Com CellCom Battery Pack Charger - Manual (Page 178)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
1 0 - 2 6
To enable beltpacks 11-20 click on the ‘System Password’ button to
open the system password dialog box.
Figure 10-33: System Password
The system password is the same password that is required to activate
the basestation and must be obtained from Clear-Com (see “Important
Installation Information” in Chapter 1. An error message will be
displayed if an invalid password is entered.
Figure 10-34: Invalid System Password Entered
Once a valid system password is entered it will be remembered by the
Configuration Editor until it is ended. If the map is saved after the
system password has been entered it will be stored in the current map
and will not have to entered again when that map is reloaded.
DECT CARRIERS
This shows the range of RF carriers that the basestation is currently
using, in MHz. The carriers that a unit is permitted to use vary from
country to country. Authorized service personnel and distributors may
change this value after entering a password - contact ClearCom sales
for details.
SYS ID
This shows part of the DECT system ID, which the beltpacks use to
identify which basestation to communicate with, and vice versa.