Clear-Com CellCom Battery Pack Charger - Manual (Page 187)

Clear-Com Communication Systems
CellCom V2.0.3 Instruction Manual
1 1 - 7
• Run the Configuration Editor and select the COM port that the
serial cable is attached to on the PC. Please refer to chapter 10
“CellCom Configuration Editor” for instructions on using the
Configuration Editor to register the beltpack.
• Power cycle the basestation and the beltpacks, and check that
they communicate successfully with each other.
BASESTATION SERIAL UPGRADER
This application is used to upgrade the firmware of the Cellcom
basestation when a new version is released.
It connects to the basestation using a crossover (Null-Modem) serial
cable plugged into the “PC PROGRAM” port. If this cable was not
shipped with the Cellcom unit, the pinout is described in Figure 11-1. It
expects to be connected to COM port 1 of the PC.
UPGRADING THE BASESTATION FIRMWARE
On launching the application a dialog box like this should appear.
Figure 11-7: Upgrading Basestation Firmware
Select “Browse”, and navigate to the location of the new basestation
firmware file. The firmware file will have a “.4kr” file extension.