CognitiveTPG B780 - Manual (Page 151)

Chapter 5: Programming commands 139
A776-PG00001 C 12/09 A776 (B780) Programming Guide
Value Definition
1D Command return indicator
49 Image Scanner
B8 Imaging function = wait for scan
s Standard imaging status
Decimal
Meaning
0 OK
1 Jam detected
2 Wait for scan document cancelled
3 Imager cover open
7 Unrecoverable hardware error
8 No stored document
9 Bottom side only
10 Top side only
11 Internal interface timeout error
12 Internal interface other error
16 No bottom image
17 No top image
18 Unsupported format
19 Tag block full
m Scanning command entry point used: 0 = no outstanding scan, 1 = slip entry, 2 = top entry
n Sensors currently covered: none = 0 value
Bit 0 =1: rear image sensor covered
Bit 1 =1: front image sensor covered
Bit 2 =1: image cover open
Bit 3=1: casette cover open
Bit 5=1: upper slip sensor covered
Bit 6=1: lower slip sensor covered
pLpH The File Index to be used by the next scan
rLrH Remaining space count of typical document scans to fit in image buffer free space
4 bytes 0
The port that is receiving the image will get the equivalent status with the image attached:
Value Definition
As above 1D 49 B8 s m n pL pH rL rH
4 bytes TIFF length if attached
TIFF TIFF containing tags and images if attached
If the image file return port is RS232, then the header and attached image file are transmitted under the settings of the
Configure RS232 File Transmit parameters.