CognitiveTPG B780 - Manual (Page 154)

Chapter 5: Programming commands 142
A776 (B780) Programming Guide A776-PG00001 C 12/09
If the image file return port is RS232, then the header and attached image file are transmitted under the settings of the
Configure RS232 File Transmit parameters.
XON-XOFF will not work for transmission of image.
Eject from Scanner
Hexadecimal: 1D BA p
Parameters: p specifies the action: 0 = eject from entry point, 1 = eject front, 2 = eject straight back, 3 = move down
into slip print position
Return: Status is returned as follows using the standard status return:
Value Definition
1D Command return indicator
49 Image Scanner
BA Imaging function = eject
s Standard imaging status as described above in section 8.2.1
s Standard imaging status
Decimal
Meaning
0 OK
1 Jam detected
2 Wait for scan document cancelled
3 Imager cover open
7 Unrecoverable hardware error
8 No stored document
9 Bottom side only
10 Top side only
11 Internal interface timeout error
12 Internal interface other error
16 No bottom image
17 No top image
18 Unsupported format
19 Tag block full
m m as in the Image Status Command return
n n as in the Image Status Command return
pL pH p as in the Image Status Command return
rL rH r as in the Image Status Command return
Description: This command ejects the document or moves it into the slip printer for further processing. A request for
moving a top inserted document down into slip print position will instead eject it out the back.