CognitiveTPG B780 - Manual (Page 73)

Chapter 5: Programming commands 61
A776-PG00001 C 12/09 A776 (B780) Programming Guide
Character width selection
Hex
Decimal Width
00 0 1 (normal)
10 16 2 (two times width)
20 32 3 (three times width)
30 48 4 (four times width)
40 64 5 (five times width)
50 80 6 (six times width)
60 96 7 (seven times width)
70 112 8 (eight times width)
Character height selection
Hex
Decimal Height
00 0 1 (normal)
01 1 2 (two times height)
02 2 3 (three times height)
03 3 4 (four times height)
04 4 5 (five times height)
05 5 6 (six times height)
06 6 7 (seven times height)
07 7 8 (eight times height)
This command is effective for all characters (except for HRI characters).
In standard mode, the vertical direction is the paper feed direction, and the horizontal direction is perpendicular to
the paper feed direction. However, when character orientation changes in 90 degree clockwise-rotation mode, the
relationship between vertical and horizontal directions is reversed.
In page mode, vertical and horizontal directions are based on the character orientation. When characters are enlarged
with different sizes on one line, all the characters on the line are aligned at the baseline.
The select print mode (1B 21 n) command can also select or cancel double-width and double-height modes. However,
the setting of the last received command is effective.
Exceptions
If n is out of the defined range, this command is ignored. This command is only valid for the receipt station.
Select or cancel white/black reverse print mode
ASCII GS B n
Hexadecimal 1D 42 n
Decimal 29 66 n
Value of n: 0 = Off
1 = On
(When 0 and 1 are the least significant bit, LSB)
Range of n: 0–255
Default: 0 (Off)
Continued . . .