Magnum Venus Plastech DuraMAX Gun DMX-3000 - Manual (Page 20)

DuraMAX Gun Manual
Rev. 12/2012 Page | 20
Assembly:
Gun Handle Assembly
1. Apply lubricant to Springs (04039-1) and insert into Gun Handle (54350-3)
2. Thread Spring Retainers (54000-1) over Springs (04039-1) into Gun Handle (54350-3)
3. Slide Spring (04070-1) onto the end of the Poppet Assembly (MG-2031)
4. Insert Poppet Assembly (MG-2031) into Valve Body (54440-1)
5. Slide O-ring (O-S-104A) over Poppet Assembly (MG-2031) and retain with Packing
Retainer (54420-1)
6. Screw Assembled Valve Body (54440-1) into the Gun Handle (54350-3)
Gun Head Assembly
1. Install new Seal (02441-1) onto Plug (53110-1) then thread Plug into Gun Head
(DMX-3001-01)
2.
Install re built Flush Valve Assembly (5104-01-01) into resin side of Gun Head
(DMX-3001-01)
3.
Install Distribution Ring (5104-18-1), into the Mix Housing (MAX-2017-T)
4.
Install new O-Ring (O-S-018) into Mix Housing (MAX-2017-T)
5.
Insert Catalyst Injector Assembly (5104-03-01) into Distribution Ring (5104-18-1).
The spring side should be facing you.
6.
Attach assembled Mix Housing (MAX-2017-T) to Gun Head (DMX-3001-1) using
the two (2) Cap Screws (F-CS-1024-10).
7.
Place New O-Ring (O-S-012) on Catalyst Fitting (MAX-2019) and Resin Fitting (MAX-
2022). Install both fittings into gun, making sure they are on the correct sides of the
gun head.