Magnum Venus Plastech DuraMAX Gun DMX-3000 User Manual
Page 23
DuraMAX Gun Manual
Rev. 12/2012
Page | 23
O-RING
20. Install Resin Needle (MAX-2010-01) thru Seal Housing (MAX-2013)
21. Slide Seal Retainer (MAX-2009) then Packing Seal (MAX-2008) over the Resin
Needle (MAX-2010-01).
22. Slide Packing Nut (MG-1022) over the Resin Needle (MAX-2010-01) and thread
into Seal Housing (MAX-2013). Just a little over finger tight – do not over tighten.
23. Thread Jam Nut (53800-1) then Needle Guide (53900-1) onto resin needle end.
24. Thread Seal Housing and Resin Needle Assembly into the Gun Head (DMX-
3001-01)
NOTE: Use caution not to bend the catalyst and resin needle while performing the
remaining assembly procedures.
NEEDLE GUIDE
JAM NUT
PACKING NUT
PACKING SEAL
SEAL RETAINER
SEAL HOUSING
RESIN NEEDLE
CARBIDE SEAT
O-RING
GUN HEAD