Magnum Venus Plastech DuraMAX Gun DMX-3000 - Manual (Page 21)

DuraMAX Gun Manual
Rev. 12/2012 Page | 21
NEEDLE
O-RING
NEEDLE HOUSING
O-RING
PACKING NUT
8. Install Needle (DMX-3004) into Needle Housing (DMX-3003) and place a new O-
ring (O-T-010) onto the end sticking out of the needle housing.
9. Screw Packing Nut (DMX-3002) onto Needle Housing (DMX-3003) over the O-
ring and needle.
NOTE: Repeat steps 8 and 9 for both Needle Housings (DMX-3003).
10. Screw both assembled Needle Housings (DMX-3003) into both the catalyst and
resin sides of the gun head.
11. Install new O-Ring (O-S-012) into Catalyst Needle Seat area of the Gun Head
(DMX-3001-01)
12. Install new O-Ring (O-S-012) on Catalyst Needle Housing (DMX-3009-02) and
thread into Gun Head (DMX-3001-01)
GUN HEAD