Meriam M2 – Series Smart Manometer - Manual (Page 13)

7
Units Select
The standard engineering units available on the Smart
Manometer are:
PSI
inH
2
0 (@20°C, 60°F and 4°C)
Kg/cm
2
kPa
mbars
Bars
cmH
2
O (@ 20°C)
inHg (@ 0°C)
mmHg (@ 0°C)
User Units
Flow Units
To change the engineering units the manometer should be
“ON” and in Measure Mode. Then follow these steps:
Keystroke Display
1. Press the PRGM
key.
Top line reads “PROGRAM
MODE” and bottom line
reads “UNITS SELECT”.
2. Press the PRGM
key. Top
line reads “UNITS
SELECT” and bottom line
shows current engineering
units.
3. Press the up or down
arrow key until desired
engineering unit is
displayed. Engineering units on bottom
line of display change.
4. Press the PRGM key
to select the
engineering unit.
Top line reads “PROGRAM
MODE” and bottom line
reads “UNITS SELECT”.
5. Press the down
arrow key.
Bottom line reads “EXIT”.
6. Press the PRGM
key. Display returns to Measure
Mode in new engineering
unit.